Hypersensitivity reduction:
> Powder concentration below 2 mg
> IsoSafe latex-free: made with polyisoprene
Tear and tensile strength:
> High stretching greater than 700%
> Uniform thickness:
– 0.28mm IsoSafe latex
– 0.25mm IsoSafe latex-free
> Tensile strength
≥ 24 MPa IsoSafe latex
≥ 20 MPa IsoSafe latex-free
Colour contrast:
> Tooth is visible in contrast with the dental arch
Pre-cut latex and non-latex dental dams used as isolation barriers during endodontic and dental procedures.
Log in to your partner area to access additional documents
Ref :
Here, we share our case studies, clinical studies and many other supports that will help you in your daily practice.

Dr Marco Morello
Preoperative X-ray on 36.

Dr Marco Morello
Initial situation prior to treatment.

Dr Marco Morello
Amalgam placed under nerve block anesthesia and built up to edge of the subgingival part using Reflectys Flow shade A3.

Dr Marco Morello
Base of cavity protected with MTA Biorep.

Dr Marco Morello
A layer of Reflectys Flow shade A3 is applied to eliminate undercuts, following the standard bonding protocol. Light curing for 20 seconds followed by detailed polishing of the preparation.

Dr Marco Morello
Digital impression of the prepared tooth and neighboring teeth.

Dr Marco Morello
Machining of the Numerys HC A2/12 block.

Dr Marco Morello
Etching of enamel and dentin with Dentoetch for 10 seconds, isolating the mesial surface of 18 with Teflon tape.

Dr Marco Morello
Apply a layer of glycerin and light cure each face of the inlay onlay for 10 seconds

Dr Marco Morello
Inlay onlay after bonding and polishing.
This site is strictly reserved for oral health professionals.
By clicking “I confirm”, I certify I am an oral health professional.